Features of the FUT043 Mi-Light RGB LED strip controller
Application for RGB tapes (multi-coloured without white)
Wireless communication with the control device
The possibility of obtaining any colour
Obtaining control of brightness intensity
Cooperation with the Wi-Fi network (additional option)
The range of I / O voltage in the range 12-24V DC
Application of several receivers to one zone
Maximum current carrying capacity 15A
The form of communication that connects the transmitter with the receiver is via radio. The signal based on 2.4GHz frequency allows for wireless installation at a level of 30 meters in an open area. When using more devices (receivers), we can create LED installations based on unlimited range, thanks to the technology of signal re-transmission. The condition of such work is to place another receiving device within 30 meters. The products cooperating with the FUT043 receiver can be found in the following table No. 1 or in the category of "related products"
Table 1. Cooperating devices with LED receiver - Mi-Light RGB LED strip controller FUT043
||Mi-Light RGB+CCT full touch remote controller FUT088
||Mi-Light 2.4GHz 4-zone RGB+CCT remote controller FUT092
||Mi-Light 8-zone RGB+CCT remote controller FUT089
||Mi-Light smart panel remote controller B0
||Mi-Light 8-zone smart panel remote controller B8
||Mi-Light 4 zone RGB+CCT smart panel remote controller B4
||Mi-Light 4-zone RGB+CCT smart panel remote controller T4
||Mi-Light WiFi iBox smart light iBox1
||Mi-Light WiFi controller iBox2
Receiver power supply - connectors for easy assembly
Receiving devices are supplied with a DC voltage of 12VDC or 224VDC, which must be supplied to the input of the device. In order to facilitate assembly, the construction of receivers consists of screw terminals, both at the entrance and at the exit, which makes it easier to bring the wires to the device. In addition, if you have a power supply that has a DC plug at the output, you can directly plug into the DC jack located next to the input terminals of the receiver. The cable connection is stable and quick to assemble.
Full control - cooperation with transmitting devices
Wireless radio route through which devices communicate provides a full range of possibilities related to control. Depending on the product, the control can be carried out with the help of many available radio remote controls operating on the 2.4 GHz frequency. This basic form of communication provides stable control of LED lighting within 30 meters in an open area. In addition, most products can be expanded with an alternative form of control, through the use of the Wi-Fi module, which allows you to connect our mobile application with a compatible device series Mi-Light. The transmitting devices cooperating with a given device can be seen above in the presented table or product parameters.
The higher load capacity of outputs - more possibilities
The radio receiver was created in a way allowing to increase the maximum load capacity of the outputs. This means that in relation to previous Mi-Light series receivers, connecting more LED strips. In total, we can charge such a device with a current of 15A.
Automatic synchronization - signal retransmission
When there are more receivers in the installation controlled by one transmitting device, the installation synchronizes together during operation, without causing any delays during the operation of the devices. Increasing the radio signal in the installation is possible by using several receivers. These devices are characterized by the transmission of the received signal to the next device, thus increasing the control range of the LED installation (Distance between the receivers cannot be greater than 30m).
Specification of FUT043 LED strip controller Mi-Light: