IR hand sensor controller ID-2058

IR hand sensor controller ID-2058 

Switch LED lights on and off without the need of touching any switch. It is dedicated to applications that require very high hygiene standards such as laboratories, hospital operating rooms. The switch guarantees safety while turning the light on in the bathroom with wet hands or any other applications where you may not physically want to touch the switch. Due to its small size (41 mm x 12 mm x 7 mm), it perfectly fits inside most commercially available aluminium profiles for LED strips. To be used with a single colour LED strips. The device works on the principle of the ON / OFF button. A wave of the hand at a distance of 5 cm will turn it ON, wave again to turn it OFF. Power max. 20W (e.g. 4m of 3528 with 60 LEDs per meter,  2.7m of 5050 with 30 LEDs per meter, 2m of 2835 with 60 LEDs per meter) 

IR hand sensor controller ID-2058 specification
Voltage: 12V

Intensity max. 1.66

Weight 1.6g

The dimensions of 41 mm x 12 mm x 7 mm
 
Please note: Before turning ON the power, check all the cable connections because possible short-circuit may damage the device. - Supply voltage controller is 12V - if this voltage is exceeded it can occur damage. 

IR hand sensor controller ID-2058 installation instructions: 

1) Solder the wires to the power supply in the solder pads on the input side (at the sensor) according to the diagram above.

2) Solder the LED strip in the solder pads on the output side. Please pay attention to the polarity (see diagram above)

3) Stick the tape LED to the profile. You should remember not to cover the infrared sensor shade. An infrared sensor cannot be obstacles in its path.