Design Light LED touch switch controller XC60

DESIGN LIGHT LED touch switch controller XC60

XC60 LED touch switch controller has a blue LED that lights up when the unit is connected to the power supply. Just touch the diffuser in a place of blue LED light to switch the strip ON/OFF. The plate has a small size (47x9x5mm) and fits all our aluminium profiles but works best with the MINI series.

Simply solder the XC60 switch to the LED strips and insert it into the profile with the use of double-sided adhesive tape and that is it! Finished! Installation of this switch takes only a few minutes.

The switch is designed for low-voltage LED strips (12VDC) and for internal use only. Designed to be used in aluminium profiles only. The total power of the light source cannot exceed 60W. During the installation, the switch cannot be connected to the power source. Before installing the switch make sure the surface of an aluminium profile is clean and degreased. The switch should be mounted by the supplied double-sided adhesive tape attached to the back of the switch. Wires should be soldered according to the right polarity. The switch soldering points marked 12V - / + according to the polarity (see assembly scheme) solder the wire from the power source 12VDC where the minimum wire cross is 2x0,35mm. Before connecting to the power source please make sure that the wiring and mounting are made correctly.

DESIGN LIGHT LED touch switch controller XC60 specification