2 in 1 contactless sensor switch controller ID-2057

2 in 1 contactless sensor switch controller ID-2057

A Contactless sensor switch derived from the detector 2in1. Switches LED lights ON and OFF without a need of touching any switch. It is dedicated to applications that require very high hygiene standards such as laboratories, hospital operating rooms. The switch guarantees safety while turning the light on in the bathroom with wet hands or any other applications where you may not physically want to touch the switch. Due to its small size (51 mm x 11 mm x 3 mm), it perfectly fits inside most commercially available aluminium profiles for LED strips. To be used with a single colour LED strips. Universal ON/OFF switch with two modes of operation: Mode 1: The device works on the principle of the ON / OFF switch. A wave of the hand at a distance of 5 cm will turn it ON, the second wave will turn it OFF. Mode 2: A sensor for cabinets.

Power max. 20W (e.g. 4m of 3528 with 60 LEDs per meter,  2.7m of 5050 with 30 LEDs per meter, 2m of 2835 with 60 LEDs per meter)

Voltage 12V

Intensity max. 1.66

Weight 3.2g

The dimensions of 51 mm x 11 mm x 3 mm

Note:

- Before turning on the power, check all the cable connections - possible short-circuit may damage the device. - Supply voltage controller is 12V - if this voltage is exceeded it can occur damage.

2 in 1 contactless sensor switch controller ID-2057 installation instructions:

1) Solder the wires to the power supply in the solder pads as input the diagram above. 2) Solder the LED strip at the exit point soldering. Please pay attention to the polarity (see diagram above) 3) Fix the detector as derived from the wire at the target site (cabinet, closet door, etc.) At a distance max. 5 cm from the door. In this mode, the sensor operates on the principle of ON / OFF. We attach the receiver when you open the door, turns off when the door is closed.