MS60 LED switch controllers

MS60 LED switch controllers

MS60 LED switch controllers are an SMD board equipped with a convenient and reliable touch switch. The plate has a small size (31x8x8mm) and fits the aluminium profile where high does not exceed 7mm.

Simply solder MS60 switch to the LED strips and insert it into the profile with the use of double-sided adhesive tape, then drill a hole in the lens above the switch with a diameter of 4-5mm, through which protrudes a touch switch. Finished! Installation of this switch takes only a few minutes.

WARNING! Please remember to supply the solder side 12V, and the lighting side LED (subtitles printed on the board) with the correct polarity.

Installation of MS60 LED switch controller

So one solution will satisfy even the most demanding customers by providing simplicity and ease of use. The maximum power that is able to handle this little switch is 60W which is more than enough for a strong LED strip 5m.

The plate of the switch can be used with LED strips mounted under the cupboard as lighting for the kitchen worktop. Due to its size, it can also be used in furniture chest and everywhere where there is contact with the LED strip eg. Wardrobes, chests of drawers, headboard, etc.

Photos of MS60 LED switch controller

Technical data:

Voltage: 12V DC

Power: 60W

International Protection rating: IP20

Dimensions: 31mm x 8mm x 8mm (height of the switch 8mm)

The first touch will switch ON, the second touch will switch OFF the lighting

These and plenty more controllers are available in our offer but if you would like to purchase any of the controllers and they are not currently available in stock on our website please contact us directly at contact@futurehousestore.co.uk for retailers that are interested in cooperation please drop us an email at wholesale@futurehousestore.co.uk