Design Light LED switch controller MS60

DESIGN LIGHT LED switch controller MS60

MS60 LED switch controller is an SMD board equipped with a convenient and reliable touch switch. The plate has a small size (31x8x8mm) and fits the aluminium profile where high does not exceed 7mm.

Simply solder MS60 switch to the LED strips and insert it into the profile with the use of double-sided adhesive tape, then drill a hole in the lens above the switch with a diameter of 4-5mm, through which protrudes a touch switch. Finished! Installation of this switch takes only a few minutes.

The switch is designed for a voltage of 12VDC and for internal use only. Designed to be used in aluminium profiles only. The total power of the light source cannot exceed 60W. During the installation, the switch cannot be connected to the power source. Before glueing the switch, the surface of an aluminium profile should be clean and degreased. The switch should be mounted by the supplied double-sided adhesive tape attached to the back of the switch. Wires should be soldered according to the right polarity. The switch soldering points marked 12V - / + according to the polarity(see assembly scheme) solder the wire from the power source 12VDC where minimum wire cross is 2x0,35mm. Before connecting to the power source please make sure that the wiring and mounting are made correctly.

Just mount the plate and make a hole in the lens with a diameter of 4-5mm for the switch.

DESIGN LIGHT LED switch controller MS60 specification